Dbx AFS224 Manuale Utente

dbx AFS224 Quick Start Guide This step by step tutorial is based on a basic configuration (AFS224 in line between mixer and amplifier) as

18. If you find that the feedback reoccurs when the Live filters are lifted, try setting a longer Live Filter Lift time or try setting it to “None” (

19. If you would like to lock the front panel (to prevent tampering), press and hold the channel 1 LIVE FILTER LIFT button. Hold this button until th

1. Go into the Setup mode by pressing and holding the channel 1 MODE button. 2. Hold this MODE button until the filter LEDs flash all the way acros

4. Select how many total filters that you want active. The default of 24 is a good place to start. However, if you want to change the total # of filt

6. To exit the setup mode, press and hold the channel 1 MODE button. Hold this button until the filter LEDs flash all the way across. 7. Press the

9. Set the “Live Filter Lift” to 10 minutes (yellow). 10. Set the “Type” to Music Medium (yellow).

11. Perform a sound check on all of the microphones that will be active. Get them as close to the performance level as possible without feedback. You

12. Pull the master faders on the mixer all the way down (no signal). 13. Check the Mode buttons. If they are not lit green, press the buttons un

14. Disengage the Bypass buttons (LEDs off). 15. Slowly raise the master faders on the mixer. As feedback occurs, Fixed filters will be set. You m

16. When you have reached the desired performance level, press the MODE buttons until they are both lit red. You are now in “Live” mode. 17. For a