Dbx 566 Manuale del Proprietario

DualVacuum TubeCompressorOwner’s Manual Version 1.0

Note that since the PeakPlusªLimiter is a fail-safe Limiter it must come after the Output Gain con-trol. If the Output Gain is set too high as compare

DITHER switchThis switch becomes active only when the optional dbx TYPE IVªConversion System digital outputmodule is installed. Refer to the manual fo

Rear PanelLINE INPUTSBoth XLR and TRS 1/4Ó connectors allow balanced or unbalanced line-level devices to be connect-ed to the input of the 566Õs Compr

SpecificationsCOMPRESSORThreshold Range: -40 dBu to +20 dBuRatio: Infinity: 1Threshold Characteristic: Selectable OverEasy¨or hard knee curvesAttack/R

SpecificationsSpecifications (cont.)Power Consumption: 30 Watts max.Fuse: 100/120V: 500mA 250V Slow Blow 5mm X 20mm230/240V: T250 mA 250V 5mm X 20mmMa

13dbx 566 Settings PagePhotocopy this page and mark the settings you use for your sessions.Session: Date:Comments:Session: Date:Comments:13

8760 South Sandy Pkwy.Sandy, Utah 84070Phone: (801) 568-7660Fax: (801) 568-7662IntÕl Fax: (603) 672-4246Questions or comments?E¥mail us at: customer@d

WARNINGFOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bathtub, wash-bowl, kit

1Table of ContentsIntroduction...2Feature

IntroductionThank you for purchasing the dbx 566 vacuum tube compressor. The 566 combines world-renowneddbx compression with the latest in vacuum tube

WarrantyThis warranty is valid only for the original purchaser and only in the United States. We warrant dbxproducts against defects in materials or w

ConnectionsTo connect the 566 to your system, refer to the following steps:¥ Turn off all equipment before making any connections.¥ Mount the 566 in a

Compressor ControlsFigure 2: Front Panel Controls+ 0 - THRESHOLD leds: The Ò+Ó led illuminates when the signal is above the OverEasy¨portion of the co

Figure 3: Hard Knee and OverEasy®Compression CurvesRATIO control:This control selects the ratio between input and the output levels for signals above

INST SwitchThis switch selects the 1/4Ó Instrument input as the source for the compressor.DRIVE controlThis control sets the amount of gain that will